Shotcrete

Spraying cement sand mix either in dry form of in wet form by hose with high velocity and pressure at higher elevation surfaces to immediate stick on surface is a shortcrete process. Its also called Gunite.

Its used in tunnels or sloped portions. Rapid hardening cement is used.

Comments

Post a Comment

Popular posts from this blog

Cc & Cu C & phi in Soils IS 2720

Coff of uniformity = The ratio D60/D10, where D60 is the particle diameter corresponding to 60 percent finer on the grain size curve and D10, is the particle diameter corresponding to 10 percent finer on the grain-size curve.                                                                                                                                                                                                         Coff of curvature = It is given by Cc =  D302/D10xD60 where D1...
Read more

Penetration Test for Bitumen IS 1203 1978

Hot the Bitumen in oven 90oc + Softening point and pour in in bowl, approx 10 mm more than expacted penetration. Use bowl depth 35 mm, dia 55 mm size for penetrations below 225 Then keep it in room temp for 1 – 11/2 hours (75 min) Then in water bath at temp 25oc for 1 – 11/2 hours (75 min) Use bowl depth 45 mm, dia 75 mm size for penetrations from 225 to 350 Then keep it in air for  11/2 -2 hours (105 min) Then in water bath at temp 25oc for 11/2 -2 hours (105 min) Then place it under the apparatus Wt of assembly should be 100 g (if 50 gm wt + needle + assembly) Wt of assembly should be 200 g (if 150 g wt + needle + assembly) For CRMB 60 penetration will be <50 Penetration ratio = Penetration at 4oc 200 gm for 60 sec ---------------------------------------------- x 100 Penetration at 25oc 100 gm for 5 sec
Read more

Role of FM of sand

The grading and maximum size of aggregates is important parameters in any concrete mix. They affect relative proportions in mix, workability, economy, porosity and shrinkage of concrete etc. Experience has shown that very fine sands or very coarse sands are objectionable – the former is uneconomical, the latter gives harsh unworkable mixes. Thus the object in this paper is to find the best fineness modulus of sand to get the optimum grading of combined aggregate (all-in-aggregate), which is most suitable, and for economy. In general, the grading of aggregates, which do not have a deficiency or excess of any size of aggregate and give a smooth grading curve, produce the most suitable concrete mix. Further a cohesive mix is also desired for the pumped concrete produced by RMC Plant. In the present investigations, effect of the grading of river sand particles has been investigated for a good Concrete mix. Sand has been sorted in three categories i.e. Fine, Medium, and Coarse. These w...
Read more